Hi, I am wrapping up my Airtex installation in my Seneca 3 and down to the rear cabin area and looking for some recommendations.
1. What is the best approach for installing the carpet on the center duct work hump, specifically at the front where the ducts split and go under the spar box? Lots of glue wrapping it around and under the ducts?
2. What is used to fastern the lower carpet sidewalls (with the plastic board backers) to the structure? I ask because my plane had some coin-dot material stuffed in there and the original mounting arrangement was no longer evident.
So close to being done, and it looks great!
Thanks in advance.
1. What is the best approach for installing the carpet on the center duct work hump, specifically at the front where the ducts split and go under the spar box? Lots of glue wrapping it around and under the ducts?
2. What is used to fastern the lower carpet sidewalls (with the plastic board backers) to the structure? I ask because my plane had some coin-dot material stuffed in there and the original mounting arrangement was no longer evident.
So close to being done, and it looks great!
Thanks in advance.
